| /**************************************************************************** |
| * arch/arm/src/nrf52/nrf52_config.h |
| * |
| * Licensed to the Apache Software Foundation (ASF) under one or more |
| * contributor license agreements. See the NOTICE file distributed with |
| * this work for additional information regarding copyright ownership. The |
| * ASF licenses this file to you under the Apache License, Version 2.0 (the |
| * "License"); you may not use this file except in compliance with the |
| * License. You may obtain a copy of the License at |
| * |
| * http://www.apache.org/licenses/LICENSE-2.0 |
| * |
| * Unless required by applicable law or agreed to in writing, software |
| * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT |
| * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the |
| * License for the specific language governing permissions and limitations |
| * under the License. |
| * |
| ****************************************************************************/ |
| |
| #ifndef __ARCH_ARM_SRC_NRF52_NRF52_CONFIG_H |
| #define __ARCH_ARM_SRC_NRF52_NRF52_CONFIG_H |
| |
| /**************************************************************************** |
| * Included Files |
| ****************************************************************************/ |
| |
| #include <nuttx/config.h> |
| #include <arch/board/board.h> |
| |
| #include "chip.h" |
| |
| /**************************************************************************** |
| * Pre-processor Definitions |
| ****************************************************************************/ |
| |
| /* Configuration ************************************************************/ |
| |
| /* Make sure that no unsupported UART, I2C master, or SPI master peripherals |
| * are enabled. |
| */ |
| |
| /* Map logical UART names (Just for simplicity of naming) */ |
| |
| #undef HAVE_UART0 |
| #undef HAVE_UART1 |
| |
| #ifdef CONFIG_NRF52_UART0 |
| # define HAVE_UART0 1 |
| #endif |
| |
| #ifdef CONFIG_NRF52_UART1 |
| # define HAVE_UART1 1 |
| #endif |
| |
| /* Check if we have a UART device */ |
| |
| #undef CONFIG_NRF52_HAVE_UART |
| #undef HAVE_UART_DEVICE |
| |
| #if defined(HAVE_UART0) |
| # define HAVE_UART_DEVICE 1 |
| #endif |
| |
| #if defined(HAVE_UART1) |
| # define HAVE_UART_DEVICE 1 |
| #endif |
| |
| /* Is there a serial console? There should be at most one defined. */ |
| |
| #undef HAVE_UART_CONSOLE |
| |
| #if defined(CONFIG_UART0_SERIAL_CONSOLE) && defined(HAVE_UART0) |
| # undef CONFIG_UART1_SERIAL_CONSOLE |
| # define HAVE_UART_CONSOLE 1 |
| #endif |
| |
| #if defined(CONFIG_UART1_SERIAL_CONSOLE) && defined(HAVE_UART1) |
| # undef CONFIG_UART0_SERIAL_CONSOLE |
| # define HAVE_UART_CONSOLE 1 |
| #endif |
| |
| #endif /* __ARCH_ARM_SRC_NRF52_NRF52_CONFIG_H */ |
