| # Licensed to the Apache Software Foundation (ASF) under one |
| # or more contributor license agreements. See the NOTICE file |
| # distributed with this work for additional information |
| # regarding copyright ownership. The ASF licenses this file |
| # to you under the Apache License, Version 2.0 (the |
| # "License"); you may not use this file except in compliance |
| # with the License. You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, |
| # software distributed under the License is distributed on an |
| # "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY |
| # KIND, either express or implied. See the License for the |
| # specific language governing permissions and limitations |
| # under the License. |
| # |
| |
| syscfg.defs: |
| STM32_FLASH_SIZE_KB: |
| description: 'Total flash size in KB.' |
| value: 1024 |
| |
| STM32_FLASH_NUM_AREAS: |
| description: 'Number of flash sectors for a non-linear STM32 MCU.' |
| value: 12 |
| |
| syscfg.vals: |
| REBOOT_LOG_FLASH_AREA: FLASH_AREA_REBOOT_LOG |
| CONFIG_FCB_FLASH_AREA: FLASH_AREA_NFFS |
| NFFS_FLASH_AREA: FLASH_AREA_NFFS |
| COREDUMP_FLASH_AREA: FLASH_AREA_IMAGE_1 |
| STM32_CLOCK_VOLTAGESCALING_CONFIG: 'PWR_REGULATOR_VOLTAGE_SCALE1' |
| STM32_CLOCK_HSI: 0 |
| STM32_CLOCK_HSE: 1 |
| STM32_CLOCK_HSE_BYPASS: 0 |
| STM32_CLOCK_PLL_PLLM: 6 |
| STM32_CLOCK_PLL_PLLN: 50 |
| STM32_CLOCK_PLL_PLLP: 2 |
| STM32_CLOCK_PLL_PLLQ: 4 |
| STM32_CLOCK_ENABLE_OVERDRIVE: 0 |
| STM32_CLOCK_AHB_DIVIDER: 'RCC_SYSCLK_DIV1' |
| STM32_CLOCK_APB1_DIVIDER: 'RCC_HCLK_DIV2' |
| STM32_CLOCK_APB2_DIVIDER: 'RCC_HCLK_DIV1' |
| STM32_FLASH_LATENCY: 'FLASH_LATENCY_5' |
| STM32_FLASH_PREFETCH_ENABLE: 1 |
| STM32_INSTRUCTION_CACHE_ENABLE: 1 |
| STM32_DATA_CACHE_ENABLE: 1 |
| # UART0 is on the large breakout connector, pins TX and RX. |
| UART_0_PIN_TX: 'MCU_GPIO_PORTB(10)' |
| UART_0_PIN_RX: 'MCU_GPIO_PORTB(11)' |
| UART_0_PIN_RTS: -1 |
| UART_0_PIN_CTS: -1 |
| # SPI0 is connected to onboard SPI Flash |
| SPI_0_PIN_SS: 'MCU_GPIO_PORTA(15)' |
| SPI_0_PIN_SCK: 'MCU_GPIO_PORTB(3)' |
| SPI_0_PIN_MISO: 'MCU_GPIO_PORTB(4)' |
| SPI_0_PIN_MOSI: 'MCU_GPIO_PORTB(5)' |
| # SPI1 is on the large breakout connector, pins A5, SCK, MO, and MI. |
| SPI_1_PIN_SS: 'MCU_GPIO_PORTC(5)' |
| SPI_1_PIN_SCK: 'MCU_GPIO_PORTB(13)' |
| SPI_1_PIN_MISO: 'MCU_GPIO_PORTB(14)' |
| SPI_1_PIN_MOSI: 'MCU_GPIO_PORTB(15)' |
| # I2C0 is on the STEMMA connector, and the small breakout connector, pins SCL and SDA. |
| I2C_0_PIN_SCL: 'MCU_GPIO_PORTB(6)' |
| I2C_0_PIN_SDA: 'MCU_GPIO_PORTB(7)' |
| TIMER_0_TIM: 'TIM9' |
