| # Licensed to the Apache Software Foundation (ASF) under one |
| # or more contributor license agreements. See the NOTICE file |
| # distributed with this work for additional information |
| # regarding copyright ownership. The ASF licenses this file |
| # to you under the Apache License, Version 2.0 (the |
| # "License"); you may not use this file except in compliance |
| # with the License. You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| # ========= |
| # |
| # Fuseki service configuration / unit file for systemd |
| # |
| # Usage: |
| # ------ |
| # |
| # 1. Place this file under /etc/systemd/system/ |
| # 2. Create a system user called "fuseki" and make sure it has permission |
| # to access the Fuseki configuration and databases |
| # 3. Adjust the paths and other settings below if necessary |
| # 4. Activate using: sudo systemctl enable fuseki.service |
| |
| [Unit] |
| Description=Fuseki |
| |
| [Service] |
| # Edit environment variables to match your installation |
| Environment=FUSEKI_HOME=/opt/fuseki |
| Environment=FUSEKI_BASE=/etc/fuseki |
| # Edit the line below to adjust the amount of memory allocated to Fuseki |
| Environment=JVM_ARGS=-Xmx2G |
| # Edit to match your installation |
| ExecStart=/opt/fuseki/fuseki-server |
| # Run as user "fuseki" |
| User=fuseki |
| Restart=on-abort |
| # Java processes exit with status 143 when terminated by SIGTERM, this |
| # should be considered a successful shutdown |
| SuccessExitStatus=143 |
| ### By default, the service logs to journalctl only. |
| ### If additional logging to a file is required, uncomment the following three lines |
| # StandardOutput=syslog |
| # StandardError=syslog |
| # SyslogIdentifier=fuseki |
| ### This logs to syslog. If, e.g., rsyslogd is used, you can provide a file |
| ### /etc/rsyslog.d/fuseki.conf, consisting of the following two lines (uncommented) |
| ### if $programname == 'fuseki' then /var/log/fuseki/stderrout.log |
| ### if $programname == 'fuseki' then stop |
| |
| |
| [Install] |
| WantedBy=multi-user.target |