| .. Licensed under the Apache License, Version 2.0 (the "License"); you may not |
| .. use this file except in compliance with the License. You may obtain a copy of |
| .. the License at |
| .. |
| .. http://www.apache.org/licenses/LICENSE-2.0 |
| .. |
| .. Unless required by applicable law or agreed to in writing, software |
| .. distributed under the License is distributed on an "AS IS" BASIS, WITHOUT |
| .. WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the |
| .. License for the specific language governing permissions and limitations under |
| .. the License. |
| |
| .. _install/setup: |
| |
| ================ |
| First-Time Setup |
| ================ |
| |
| CouchDB 2.0 can be used in a single-node or clustered configuration. |
| Below are the first-time setup steps required for each of these |
| configurations. |
| |
| .. _install/setup/single: |
| |
| Single Node Setup |
| ================= |
| |
| A single node CouchDB 2.0 installation is what most users will be using. |
| It is roughly equivalent to the CouchDB 1.x-series. Note that a |
| single-node setup obviously doesn't take any advantage of the new |
| scaling and fault-tolerance features in CouchDB 2.0. |
| |
| After installation and initial startup, visit Fauxton at |
| ``http://127.0.0.01:5984/_utils#setup``. You will be asked to set up |
| CouchDB as a single-node instance or set up a cluster. When you click |
| “Single-Node-Setup”, you will get asked for an admin username and |
| password. Choose them well and remember them. You can also bind CouchDB |
| to a public port, so it is accessible within your LAN or the public, if |
| you are doing this on a public VM. The wizard then configures your admin |
| username and password and creates the three system databases _users, |
| _replicator and _global_changes for you. |
| |
| Alternatively, if you don't want to use the “Single-Node-Setup” wizard |
| and run 2.0 as a single node with admin username and password already |
| configured, make sure to create the three three system databases manually |
| on startup: |
| |
| .. code-block:: sh |
| |
| curl -X PUT http://127.0.0.1:5984/_users |
| |
| curl -X PUT http://127.0.0.1:5984/_replicator |
| |
| curl -X PUT http://127.0.0.1:5984/_global_changes |
| |
| See the next section for the cluster setup instructions. |
| |
| .. _install/setup/cluster: |
| |
| Cluster Setup |
| ============= |
| |
| As configuration has many steps, see the :ref:`Cluster Reference Setup |
| <cluster/setup>` for full details. |