////
Licensed to the Apache Software Foundation (ASF) under one
or more contributor license agreements.  See the NOTICE file
distributed with this work for additional information
regarding copyright ownership.  The ASF licenses this file
to you under the Apache License, Version 2.0 (the
"License"); you may not use this file except in compliance
with the License.  You may obtain a copy of the License at

  http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing,
software distributed under the License is distributed on an
"AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
KIND, either express or implied.  See the License for the
specific language governing permissions and limitations
under the License
////

// This assembly is included in the following assemblies:
//
// configuring-logging.adoc

[id='configuring-default-logging-{context}']
= Configuring default logging

You can specify the types of events that should be logged, the format of the log entries, and where those entries should be sent.

.Procedure

. In the `{RouterConfigFile}` configuration file, add a `log` section to set the default logging properties:
+
--
This example configures all logging modules to log events starting at the `info` level:

[options="nowrap",subs="+quotes"]
----
log {
    module: DEFAULT
    enable: info+
    includeTimestamp: yes
}
----

`module`:: Specify `DEFAULT`.

`enable`:: The logging level. You can specify any of the following levels (from lowest to highest):
+
* `trace` - provides the most information, but significantly affects system performance
* `debug` - useful for debugging, but affects system performance
* `info` - provides general information without affecting system performance
* `notice` - provides general information, but is less verbose than `info`
* `warning` - provides information about issues you should be aware of, but which are not errors
* `error` - error conditions that you should address
* `critical` - critical system issues that you must address immediately

+
To specify multiple levels, use a comma-separated list. You can also use `+` to specify a level and all levels above it. For example, `trace,debug,warning+` enables trace, debug, warning, error, and critical levels. For default logging, you should typically use the `info+` or `notice+` level. These levels will provide general information, warnings, and errors for all modules without affecting the performance of {RouterName}.

`includeTimestamp`:: Set this to `yes` to include the timestamp in all logs.

For information about additional log attributes, see link:{qdrouterdConfManPageUrl}#_log[log] in the `qdrouterd.conf` man page.
--

. If you want to configure non-default logging for any of the logging modules, add an additional `log` section for each module that should not follow the default.
+
--
This example configures the `ROUTER` logging module to log `debug` events:
[options="nowrap",subs="+quotes"]
----
log {
    module: ROUTER
    enable: debug
    includeTimestamp: yes
}
----
--

.Additional resources

* For more information about viewing and using logs, see xref:troubleshooting-{context}[].