/*
 * Licensed to the Apache Software Foundation (ASF) under one
 * or more contributor license agreements.  See the NOTICE file
 * distributed with this work for additional information
 * regarding copyright ownership.  The ASF licenses this file
 * to you under the Apache License, Version 2.0 (the
 * "License"); you may not use this file except in compliance
 * with the License.  You may obtain a copy of the License at
 *
 *   http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing,
 * software distributed under the License is distributed on an
 * "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
 * KIND, either express or implied.  See the License for the
 * specific language governing permissions and limitations
 * under the License.
 */

#import <XCTest/XCTest.h>

@interface WeexUITestDemoUITests : XCTestCase

@end

@implementation WeexUITestDemoUITests

- (void)setUp {
    [super setUp];
    
    // Put setup code here. This method is called before the invocation of each test method in the class.
    
    // In UI tests it is usually best to stop immediately when a failure occurs.
    self.continueAfterFailure = NO;
    // UI tests must launch the application that they test. Doing this in setup will make sure it happens for each test method.
    [[[XCUIApplication alloc] init] launch];
    
    // In UI tests it’s important to set the initial state - such as interface orientation - required for your tests before they run. The setUp method is a good place to do this.
}

- (void)tearDown {
    // Put teardown code here. This method is called after the invocation of each test method in the class.
    [super tearDown];
}

- (void)testExample {
    // Use recording to get started writing UI tests.
    // Use XCTAssert and related functions to verify your tests produce the correct results.
}

@end