This bash script sets up a k8s cluster using kind and metallb on Linux.
WARNING: when it runs in an environment other than Linux, it will only produce an error message.
The following dependencies must be installed before running the script:
Usage:
./setupkind.sh --cluster-name cluster1 --k8s-release 1.22.1 --ip-octet 255 Where: -n|--cluster-name - name of the k8s cluster to be created, cluster1 will be used if not given -r|--k8s-release - the release of the k8s to setup, latest available if not given -s|--ip-octet - the 3rd octet for public ip addresses, 255 if not given, valid range: 100-255 -h|--help - print the usage of this script
The ip-octet parameter controls the IP range that metallb will use for allocating the public IP addresses for load balancer resources.
The public IPs are dictated by the docker network's subnet which KinD creates when it creates a k8s cluster. This parameter is used as the 3rd octet for the public IP v4 addresses when a load balancer is created. The default value is 255. The first two octets are determined by the docker network created by KinD, the 4th octet is hard coded as 200-240. As you might have guessed, for each k8s cluster one can create at most 40 public IP v4 addresses.
The ip-octet parameter is not required when you create just one cluster, however, when running multiple k8s clusters it is important to proivde different values for each cluster to avoid overlapping addresses.
For example, to create two clusters, run the script two times with the following parameters:
./setupkind.sh --cluster-name cluster1 --ip-octet 255 ./setupkind.sh --cluster-name cluster2 --ip-octet 245